Mounting instructions

Mount your display carefully.

Installation guide for MACHASE Snap Mag, PSA, and BGS wall displays.

Proudly made in Canadahello@machase.shop

In the box

1 front cover · 1 mid frame · 4 standoffs · 4 drywall anchors · 4 screws · 2–9 Snap Mags only when the Snap Mag version is purchased

Tools needed

Screwdriver · level · drill · drill bit sized for the supplied drywall anchors

Before drilling

These instructions assume drywall. For masonry, tile, wood, or another surface, use suitable fasteners. Check for concealed wiring and plumbing before drilling.

  1. 01

    Leave the protective film in place

    Do not remove the protective film from the front cover or mid frame until the display is ready for final assembly. The film protects the acrylic while you position and drill.

  2. 02

    Position the front cover

    Hold the front cover against the wall at the desired location. Use the cover itself as the mounting template.

  3. 03

    Level the cover

    Place a level along the top edge of the front cover. Adjust until the bubble is centred, then keep the cover steady.

  4. 04

    Mark all four holes

    With the cover held level, mark the wall through each of the four corner mounting holes. Remove the cover and set it on a clean surface.

  5. 05

    Drill the anchor holes

    At each mark, drill straight into the drywall using a bit that matches the supplied anchor. Do not oversize the holes.

  6. 06

    Install the drywall anchors

    Insert one anchor into each drilled hole and press or tap it gently until it sits flush with the wall surface.

  7. 07

    Install the standoff bases

    Separate each cap from its standoff base. Drive a supplied screw through each base and into the anchor. Tighten until secure and snug—do not overtighten.

  8. 08

    Load and assemble the display

    On a clean, flat surface, remove the protective film from both sides of the acrylic pieces. Insert the card holders into the mid frame, then place the front cover on top. For the Snap Mag version, place each card in its Snap Mag first. Remove dust with a clean microfiber cloth if needed.

  9. 09

    Mount the assembly and fit the caps

    Support the assembled display and align its four holes with the mounted standoff bases. Place a gasket between the rear acrylic and each base, and another between the front cover and each cap. Thread on all four caps by hand, then tighten evenly until just snug.

Clean gently

Dust with clean, soft microfiber. For fingerprints, lightly dampen the cloth with water and a drop of mild dish soap, or use an acrylic-safe cleaner. Apply cleaner to the cloth—not directly over the cards.

Avoid damage

Do not use glass cleaner, ammonia, alcohol, acetone, solvents, abrasives, or paper towels. Never scrape the acrylic, and do not overtighten the standoff hardware.

Protect the cards

Avoid excessive heat and direct sunlight. The display does not guarantee UV protection. When changing cards, support the display and work on a clean, flat surface.

Hardware order: Wall → standoff base → rear gasket → mid frame + front cover → front gasket → cap